-40%
1/2 inch floor standing Duralast drill press with variable speed drive
$ 184.8
- Description
- Size Guide
Description
Floor standing Duralast 1/2-inch drill press with variable speed drive. Condition is "Used". The quill was rebuilt 4 years ago with new bearings and a dc motor drive put on to replace the step pulleys. Made in Taiwan and originally purchased in 1994.The motor is a Leeson 1 horsepower dc motor and the drive is based on a Penta Power KBIC dc motor controller. It operates on 110 volts ac. This provides variable speeds (0-3500 rpm), forward and reverse directions and quick stop so you don’t have to wait for the spindle to coast to a stop. The drive and a tachometer are housed in a welded steel box mounted on the left side of the head. As shown in the photo, the motor drives the quill directly through a belt. The geometry is such that the belt slaps the housing when you turn it on at high rpms. This results in an annoying noise for a few seconds. This could be be corrected by shifting the motor to the left on the mounting, but I just haven’t done it.
The table is 11 1/2 inches in diameter and the throat depth is 6-5/8 inches. The drill press is 62-1/2 inches high. During my last move the plastic handle that raises and lowers the table was broken. I repaired the handle and lengthened it as shown in the photo.
My requirments for hole drilling have finally exceeded this machine’s capability so I bought a heavier drill press.
Local pickup only.